– Possible work-around of the ‘currentHelper’ problem – Italian translation of keys description, by Paxly – Support for baler-and-wrapper combination FBP 3135 (Kuhn DLC) To stop following, press the same action again (RIGHT CTRL + F). It is possible to “pause” driving, and then later “resume” following the leader’s trail, using the wait/resume action (RIGHT CTRL + H). If no “ trail crumbs” can be found, or the vehicle already is followed by another, a warning will appear and you will have to either move a little bit further towards/back, or change to follow another vehicle. To follow some vehicle, point your own vehicle towards it and press the start action (RIGHT CTRL + F). Note: Each set of action-keys must use the same modifier-key! Press-and-hold RIGHT SHIFT + W/S to repeat decrease/increase in steps of 1. Press-and-hold RIGHT SHIFT + X = Invert the follower’s offset (left-to-right, right-to-left). RIGHT SHIFT + X = Toggle the follower’s offset between zero and last value. RIGHT SHIFT + A/D = Adjust the follower’s left/right offset, in steps of 0.5. RIGHT SHIFT + W/S = Decrease/increase the follower’s distance to me, in steps of 5.
RIGHT SHIFT + H = Pause/resume the follower. Press-and-hold RIGHT CTRL + W/S to repeat decrease/increase in steps of 1.īehind – To control the vehicle that is following behind me (if any): Press-and-hold RIGHT CTRL + X = Invert the offset (left-to-right, right-to-left). RIGHT CTRL + X = Toggle offset between zero and last value. RIGHT CTRL + A/D = Adjust left/right offset when following, in steps of 0.5. RIGHT CTRL + W/S = Decrease/increase following distance, in steps of 5. RIGHT CTRL + F = Start/stop following the vehicle in front (if possible). Myself – For the vehicle the player is driving: The action-keys, which can be changed in Options – Controls, are defined in two sets:
vehicle-A follows vehicle-B follows vehicle-C follows vehicle-A – will make the beaconlights repeatedly turn on and off. – Turning on beaconlights, when having set up a circular convoy – i.e. This is most obvious when reaching a turn at high speeds, and trying to “get back on track”. – Some vehicles may start to zig-zag, in the attempt at following the “trail”, due to trying to touch every “trail crumb”. – The speed of followers may not always be 100% accurate as it could be, with regards to how fast/slow they should drive when following the “trail”.
Before telling about the controls, here’s a list of known problems that may occur when you use it:
0 kommentar(er)
